Plumbing service

faults. Frequently performed hydraulic services for apartments are repairing a leaky faucet or washing machines, which ceased to spin the laundry. Similar repairs are done at home. But in such buildings often you have to also carr

Plumbing service plumbing Kingston

Repair plumbing services performed in the flats

To common plumbing services should be installation of new sanitary facilities and repair of these devices and mending other hydraulic faults. Frequently performed hydraulic services for apartments are repairing a leaky faucet or washing machines, which ceased to spin the laundry. Similar repairs are done at home. But in such buildings often you have to also carry out work related to repair leaks resulting in the installation of plumbing. This is because the state of the responsibility of owners of housing blocks and homes can have installations mounted a dozen years earlier. Similar situation may occur also in the case of hospitals.


Plastic pipework

Plastic pipework is used for the conveyance of drinking water, waste water, chemicals, heating fluid and cooling fluids, foodstuffs, ultra-pure liquids, slurries, gases, compressed air and vacuum system applications.

Plastic pipe systems fulfil a wide variety of service requirements. Product standards for plastics pipe systems are prepared within the standards committee known as CEN/TC155. These requirements are precisely described in a complete set of European Product Standards for each application alongside their specific characteristics.

For example:

Conveyance of drinking water: Hygienic requirements

Conveyance of gas: Highest Safety requirements

Plastic pipes for radiant heating and floor heating: Temperature resistance over decades

Sewer applications: High chemical resistance.

Plastic pipes are perfectly capable of fulfilling the specific requirement for each application. They do so with a high level of performance over a long lifetime and with reliability and safety.

The key factor for success is achieved by maintaining consistently high quality levels. For plastic pipe products, these levels are closely defined by the different standards.

Źródło: https://en.wikipedia.org/wiki/Plastic_pipework


Elbows - not only your body parts

An elbow is a pipe fitting installed between two lengths of pipe or tubing to allow a change of direction, usually a 90° or 45° angle, though 22.5° elbows are also made. The ends may be machined for butt welding, threaded (usually female), or socketed, etc. When the two ends differ in size, the fitting is called a reducing elbow or reducer elbow.

Elbows are categorized based on various design features as below:

Long Radius (LR) Elbows ? radius is 1.5 times the pipe diameter
Short Radius (SR) Elbows ? radius is 1.0 times the pipe diameter
90 Degree Elbow ? where change in direction required is 90°
60 Degree Elbow ? where change in direction required is 60°
45 Degree Elbow ? where change in direction required is 45°

A 90 degree elbow is also called a "90 bend" or "90 ell". It is a fitting which is bent in such a way to produce 90 degree change in the direction of flow in the pipe. It is used to change the direction in piping and is also sometimes called a "quarter bend". A 90 degree elbow attaches readily to plastic, copper, cast iron, steel and lead. It can also attach to rubber with stainless steel clamps. It is available in many materials like silicone, rubber compounds, galvanized steel, etc. The main application of an elbow (90 degree) is to connect hoses to valves, water pressure pumps, and deck drains. These elbows can be made from tough nylon material or NPT thread.

Źródło: https://en.wikipedia.org/wiki/Piping_and_plumbing_fitting



© 2019 http://informator.swiebodzin.pl/